- Location
- Ponderay, ID, US
- Type
- Full-time
- Department
- IT
- Visa
- Not sponsored
- Source
- Breezy HR
Description
About the Job
Day & Swing Shift
CNC Programmer/Operator required skills include:
- Must have previous CNC Mill experience.
- Proficiency in MasterCAM programming X.
- Set-up, run & operate CNC Mill.
- Fixturing for complicated & multi-part production runs.
- QA is capable of including geometric tolerancing.
- Strong problem-solving skills.
Typical Benefits Package:
- This is a full-time position. Nights - 9/80 schedule -
- 1st week: 2:00pm – 11:30pm. Mon – Thu and 2:00pm - 10:30pm Fri., 2nd week 2:00pm – 11:30pm. Mon – Thu and Friday off
- Benefits package available : Medical, Dental, Optical, PPTO, 401K.
- Salary: Depending on Capabilities and Experience
Additional Requirements
- Must pass a pre-employment drug screening and background check.
- U.S. work authorization required.
Cygnus, Inc. is an equal opportunity employer and complies with all applicable federal, state, and local fair employment practices laws. Cygnus strictly prohibits and does not tolerate discrimination against employees, applicants, or any other covered persons because of race, color, sex (including pregnancy), age, national origin or ancestry, ethnicity, religion, creed, sexual orientation, gender identity, status as a veteran, and basis of disability or any other federal, state or local protected class. This policy applies to all terms and conditions of employment, including, but not limited to, hiring, training, promotion, discipline, compensation, benefits, and termination of employment.
Cygnus complies with the Americans with Disabilities Act (ADA), as amended by the ADA Amendments Act, and all applicable state or local law.
Cygnus, Inc participates in E-verify and will provide the federal government with your Form I-9 information to confirm that you are authorized to work in the U.S.