Carpenter (Punch Work & Site Support)

Essential Responsibilities

• Perform carpentry punch work to complete project closeout items and quality corrections.
• Install, repair, maintain, and relocate temporary barricades as required to ensure site safety and compliance.
• Execute miscellaneous carpentry tasks including framing repairs, trim work, hardware installation, and general construction support.
• Read and interpret work orders, project plans, and supervisor instructions.
• Maintain a safe, clean, and organized work area.
• Inspect completed work to ensure quality standards and project specifications are met.
• Coordinate effectively with site supervisors, subcontractors, and project personnel.
• Follow all OSHA regulations and company safety procedures.

Required Qualifications

• OSHA 10 Certification (required).
• Minimum of 3 years of commercial or industrial carpentry experience preferred.
• Experience performing punch list and finish carpentry work.
• Ability to work independently with minimal supervision.
• Reliable transportation and dependable attendance.
• Strong attention to detail and commitment to quality workmanship.

Tools Required

Candidates must provide and maintain their own standard carpentry tools, including but not limited to:

• Hammer
• Tape measure
• Utility knife
• Speed square
• Chalk line
• Pry bar
• Hand saws
• Levels
• Drill/driver and bits
• Tool belt and basic hand tools necessary to perform carpentry punch work

Physical Requirements

• Ability to lift and carry up to 50 pounds regularly.
• Frequent standing, walking, bending, kneeling, climbing, and reaching.
• Ability to work indoors and outdoors in varying weather conditions.
• Ability to safely navigate active construction sites.